HoustoncorsaB
Member
Registered: 8th Jan 12
User status: Offline
|
Hi. This is my first post on the forum..
I have a V reg 2000 model corsa 1.2 sxi..
Since owning the car it has been very slow to get going when accellerating, mainly when pulling away at junctions.. On the odd occation the engine light would come on then off..
Scanned the car for codes.. Found No RPM signal code..
Replaced crank sensor, timing chain kit and tried a new MAF sensor, but still the problem is there..
Has anyone had this problem before???
Cheers!
[Edited on 09-01-2012 by HoustoncorsaB]
|
HoustoncorsaB
Member
Registered: 8th Jan 12
User status: Offline
|
Anyone??? 
|
Matty W
Member
Registered: 31st Jan 11
Location: Ashton-in-Makerfield, Greater Manchester
User status: Offline
|
ive had a few issues with mine and a freind with a 1.2 has had a few issues. Mine was caused by the idle control motor. revs dropped too low, difficulty pulling off. a friends had an issue with a leaking manifold/cat gasket. was blowing past and lambda wasnt reading correctly.
not sure about the no rpm signal though, if its all plugged in correctly it should be ok.
did you make sure you'd removed the old washer when you fitted the new sensor?
[Edited on 12-01-2012 by Matty W]
|
span8v
Member
Registered: 12th Jan 10
Location: Deal, Kent
User status: Offline
|
Rpm signal is either crank sensor or cam sensor usually mate
|
Joe
Member
Registered: 20th Jun 04
Location: Hesketh Bank, Lancashire
User status: Offline
|
Pretty sure they say no rpm signal just because the engine isn't running on them. Clear the codes and read them again but with the engine running.
Symptoms sound like a mass air flow problem.
|
