myke
Member
Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline
|
in the middle of putting my car back together after having the head off.
i've got a few hoses to go back on and i've forgotten where they go.
i've got the matrix stubs, hard tube stub, cylinder head stub, and header tank exit. but thats 5 places, and i've six ends. where's the other that i've forgotten and which hose goes where?
cheers 
|
ainsley_brader
Member
Registered: 24th Mar 02
Location: Tattershall, Lincolnshire
User status: Offline
|
is there one on the back/bottom of the inlet manifold?
|
myke
Member
Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline
|
only one this size that i can think off is the stub for the idle control valve.
there's a couple of smaller ones. one to the header tank, one to the head.
can't think that there are any others on the manifold.
|
ainsley_brader
Member
Registered: 24th Mar 02
Location: Tattershall, Lincolnshire
User status: Offline
|
is there one on the back/bottom of the inlet manifold?
|
myke
Member
Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline
|
only an air one for icv afaik
|
lee mitchell
Member
Registered: 26th Jan 01
Location: kent...drive's: eveyones conversion cars hard lol
User status: Offline
|
first one goes from passenger side heater matrix to plastic trunking on block, last one goes from drivers side of heater matrix to side of head. middle one goes fromplastic trunking round block to header tank i think looking at it
|
myke
Member
Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline
|
cheers Lee. 
|
