ste_p23
Member
Registered: 29th Dec 08
Location: Hindley,Wigan
User status: Offline
|
ive got the inlet manifold kit from flame what else do i need to get to make it fit the car he did say but my mind has gone blank was it gasket somethings...........
[Edited on 11-03-2009 by ste_p23]
|
neilb1
Member
Registered: 7th Jul 08
Location: Lancashire
User status: Offline
|
says on the fitting sheet he gave you with kit gasket sealer and upper inlet gasket thats all can do in 3 hours
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
get the gasket that sits between the two halves of the inlet, and the gasket that sits between the throttle body and the inlet manifold. and some gasket sealant to put either side of the gasket.
also, you'll need a 1/4 drive rachet with an extension bar and a universal joint to get to the bolts to screw the TB to the inlet
[Edited on 12-03-2009 by Sean-B]
|
