C4RL0
Member
Registered: 30th Sep 06
Location: Cumbria
User status: Offline
|
I'm replacing the oil pump on my LET before I put it in the Corsa, but can't get the fooking crank bolt out 
It's on the engine stand, so i've got enough resistance to work against but it won't come out! I've even been bashing seven shades of shit out of the strong arm and still no luck, am I doing some thing wrong?
|
C4RL0
Member
Registered: 30th Sep 06
Location: Cumbria
User status: Offline
|
Right, forget that first answer. I finally got it off, me hanging on the breaker bar and someone else hammering fook out of it.
Got another problem know, is there any other way to get the pulley of the key?
|
paul.mitchell1984
Member
Registered: 31st Aug 06
Location: Wakefield
User status: Offline
|
easiest way i found to get bolt out was to put socket on with a bar that will reach floor and turn car over (not start) and it losens it, pulley just comes off? try taping it
|
C4RL0
Member
Registered: 30th Sep 06
Location: Cumbria
User status: Offline
|
Cheers  Got it off, took a little more than tapping it Though 
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
use a nice powerfull impact wrench is the easiest way
|
csweatherston
Member
Registered: 16th Jan 06
Location: Devon
User status: Offline
|
agree, impact wrench running 150psi usually works well...
to get the pully off, soak the centre with wd40, then tap it untill its loose
|
