shorty235
Member
Registered: 14th Dec 03
Location: South Shields, Tyne and Wear
User status: Offline
|
got some et40 wheels ang going to get them machined down.
is 49 best or lower due to size of wheel, catching on the inside?
|
diddon
Member
Registered: 23rd Apr 02
User status: Offline
|
corsa b/c
|
John
Member
Registered: 30th Jun 03
User status: Offline
|
Is 9 mil not a lot to machine off?
|
Adam_B
Member
Registered: 13th Dec 00
Location: Lancashire
User status: Offline
|
depends what corsa it is
|
Bullet Proof SRi
Member
Registered: 11th Jul 05
Location: UK - Clacton on sea - Essex
User status: Offline
|
i think 9 ml seems alot to take off a wheel, would be worried about the wheels strength, i would take 5ml off and have 45offset
|
shorty235
Member
Registered: 14th Dec 03
Location: South Shields, Tyne and Wear
User status: Offline
|
its a corsa b
|
corsaggh
Member
Registered: 28th Feb 05
Location: Bristol
User status: Offline
|
6ml is the max you should take off, and even then the wheels would have lost a bit of there strength.
|
shorty235
Member
Registered: 14th Dec 03
Location: South Shields, Tyne and Wear
User status: Offline
|
well im not getting the wheels machined anymore after looking at the inside of the wheel i think even 5mm will be too much and weaken the wheel so il just get some new ones and will put these up for sale.
they are 17" toora t240 et40 if anyone interested.
is it possible to fit 17s without any rubbing on a corsa b lowered 60mm?
|
