*CorsaCal*
Member
Registered: 3rd Oct 10
Location: Leicestershire Drives: 20XE Corsa
User status: Offline
|
Hi all i have timed the engine up as according to the haynes manual but im not happy that the belt is tight enough. I fitted it so that the long side is taught then turned the engine over 2 times and nipped the 13mm bolt on the tensioner but i can grab the belt in between the cams and wobble it up and down i would say excessivly. the 13mm is about in the middle on the tensioner now. Anyone have any tips?
Cheers 
|
bigron1988
Member
Registered: 29th Aug 09
Location: Southport, Merseyside
User status: Offline
|
before you tension it take all the slack out of the long part of the belt so the slack will be by the tension er then when you move the tensioner it will take the slack out
|
*CorsaCal*
Member
Registered: 3rd Oct 10
Location: Leicestershire Drives: 20XE Corsa
User status: Offline
|
And then turn it over twice and it should self tension or do you have to get a ratchet in the square hole and lever it over?
|
Mark.W
Member
Registered: 3rd Jan 07
Location: County Durham
User status: Offline
|
Remove that spring also that what i was told when i put my pic up.
|
*CorsaCal*
Member
Registered: 3rd Oct 10
Location: Leicestershire Drives: 20XE Corsa
User status: Offline
|
I have heard that before. Is that just incase it falls of whilst running?
|
bigron1988
Member
Registered: 29th Aug 09
Location: Southport, Merseyside
User status: Offline
|
as you go to tension it stick a 3/8 ratchet on a extension into the square hole and turn it anti clockwise to take the tension out of the belt, then tighten the bolt, turn it over 2 times and make sure the marks all line up and that the belt aint to loose/tight ,if so re do it aging
|
*CorsaCal*
Member
Registered: 3rd Oct 10
Location: Leicestershire Drives: 20XE Corsa
User status: Offline
|
Ok cheers mate. I have done this a few times but prehaps im not putting enough pressure on the ratchet. Ill have another go.
|
FlaFFy_91
Premium Member
Registered: 30th Sep 08
Location: Formby, Merseyside
User status: Offline
|
It doesn't self Renton like some mate. Also yes loose the spring. From what I've heard it can cause chaos
Just do as Ben said tbh and you wont go wrong
|
*CorsaCal*
Member
Registered: 3rd Oct 10
Location: Leicestershire Drives: 20XE Corsa
User status: Offline
|
ok cheers matey ill have another go
|
reecegsi
Member
Registered: 16th Mar 11
Location: birmingham
User status: Offline
|
Yh when cambelt tightened the spring can have alot of tension and pull tensioner which looses timing slips and you have 16 bent valves happened on 3 of my mates xe's
|
