te17
Member
Registered: 18th May 08
Location: west london
User status: Offline
|
right where do i start, i bought my x14xe sport and it popped cylinder 4 so i fitted a x16xe into the car using the 1.4's flywheel, a new clutch and the 1.4 sports gearbox which i believe is a f13 ??
that then popped second gear so ive picked up an f15 and mated it to the engine , but now it feels like the clutch is dragging and not disengaging , i have to force it in to gear and it starts to pull / judder with the clutch down and reverse wont engage.
ive adjusted the cable with no luck,
and i know that reverse gear has no syncro mesh so it wont go in if theres clutch drag
so are the x14xe and x16xe flywheels and clutches the same between f15 and f13 gearboxes
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
yea should just swap straght over no problem. if you can id take it off again and check the bearing and release arm
|
te17
Member
Registered: 18th May 08
Location: west london
User status: Offline
|
hmm strange , as when i originally recieved the donor 1.6 it had a different flywheel on looked more like a pot type than the flat one im using
|
gez bay
Member
Registered: 14th Feb 08
Location: South Wales drives: Vxr
User status: Offline
|
x14xe and x16xe have the same gear boxes, and the x14xe has a lighter fly wheel so it needs a different clutch iirc
|
te17
Member
Registered: 18th May 08
Location: west london
User status: Offline
|
so overall aslong as i have the x14xe flywheel and matching clutch it fits in both the f15 and f13
|
gez bay
Member
Registered: 14th Feb 08
Location: South Wales drives: Vxr
User status: Offline
|
the f15 defenatley will, not too sure about the f13, i think the f13 is out of the nova?? shorter ratio on the f13 iirc
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
they should fit exactly the same. x14 fly is flat x16 is pot so use different clutch covers but the clutch plate is the same.
|
