Ben ev
Member
Registered: 23rd Oct 05
Location: kingslynn / torquay
User status: Offline
|
ime replumbing all the brake pipes on the gsi but not sure whats the best way to go about it. the abs has been binned and has rear discs on back now. front uses call turbo calipers and fiat turbo discs 284mm. the master cylinder is standad gsi 2 outlet one. should i run the two lines to a spliter on the bulkhead like the none abs corsa and place the regulaters above the rear beam or can you do things a better way, also wheres the best place to get some 3/20 ones as metec wont near £100. will some from say a astra gsi from the scrappy fit, bearing in mind they attach straight onto the master cylinder. was also continplating using a bias valve near the handbrake but wont to keep away from interior mods if possible. cheers
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
I would run the 2 lines into a standard corsa splitter box then use adjustable brake bias valves on the rear lines.
|
Ben ev
Member
Registered: 23rd Oct 05
Location: kingslynn / torquay
User status: Offline
|
mounted inside the car? would prefer external regulators really. got the splitter off the old corsa so can use that. a mate of mine has just bought a new kit to make the pipes. said will get all the unions and copper pipe for about £20 quid not including valves/ regulators
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
rally design do sell external bias valves as well.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
or actually speak to compbrake, far more helpfull with brake bits:
www.compbrake.co.uk
|
Ben ev
Member
Registered: 23rd Oct 05
Location: kingslynn / torquay
User status: Offline
|
this the one?
http://www.compbrake.co.uk/brake_p2.htm
sent them an email to make sure..
|
