CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
i have modified my pipe from air filter to top of inlet
i have put a std corsa airboc on and drilled it an put KnN filter in it but the two sensors on the rubber pipe ? what do they do cos now i have the eml light on ma dash these two wrer unplugged for a couple of minutes but now the car revs stupidly
what could the problem be do these need to be sat at a certain angle or sum thing
dunno if it will make a difference another sensor has gone dodgy today this one is the one on the radiator that activates the fan my car was boiling water so i have hard wired the fan for the time being will this cause bad idle an show the eml
Just to the left of the sfi box is the pipe i am on about there are two sensors
http://car-maintenance.org/cavlove/images/sale/PICT1922.jpg
[Edited on 17-04-2006 by CoastalCorsa]
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
any one help
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
possibly the afm.
clean the contacts on the plug and the sensor, then give it another try. thats where I would start anyway
[Edited on 17-04-2006 by corsa808]
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
which one is afm the smaller of the 2
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
left is air temp sensor, right is afm
|