joeglow
Member
Registered: 29th Apr 03
User status: Offline
|
Hi
I know this topic has been covered before, but I just want to see if anyone has any new or different ideas.
I have a company car, which I mainly use and a Corsa Sport 1.4 16v which I use at the weekends and sometimes during the week (standard at the minute)
Wat engine mods could I use to get serious gains from this engine, (cams, inlet manifold, uni-chip, upgraded full exhaust system and induction kit etc
What about throttle bodies on these engines, do they give much performance and can the engine handle the power from them.
Also I was thinking of putting a set of 16 inch rims on the car and lowering it 60mm. Should I try and get rims with a et49 offset so no arch work will be needed.
Thanks
|
corsatpot
Member
Registered: 4th Jul 05
Location: Kent
User status: Offline
|
http://www.corsasport.co.uk/board/viewthread.php?tid=191112
plus yeah you have gota get as close to et49 as poss!! lowering on close to et49 wheels should be fine! tommy
|
corsatpot
Member
Registered: 4th Jul 05
Location: Kent
User status: Offline
|
http://www.corsasport.co.uk/board/viewthread.php?tid=106721
|
joeglow
Member
Registered: 29th Apr 03
User status: Offline
|
Cheers mate, does anyone know wat parts I would need to reach at least 130 bhp.
|
corsacalvin
Member
Registered: 18th Nov 05
Location: gloucester
User status: Offline
|
manztel box,head wrk,remap n cams most prob wit pulleys
|
RyeSt
Member
Registered: 13th May 04
Location: North East
User status: Offline
|
http://www.corsasport.co.uk/board/viewthread.php?tid=296281
|
Dean_W
Member
Registered: 13th Dec 05
Location: Downham Market, Norfolk
User status: Offline
|
quote: Originally posted by corsacalvin
manztel box,head wrk,remap n cams most prob wit pulleys
I'm sure the pulleys have sensor pickups on, therefore they are expensive and only a few companys make them.
|