RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
Anyone got the torque settings? And the stretch limits? For a X16XE.
Ta.
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
Found them on SBD site.
RB2/RB2K (8mm x 1.25mm) 1.4/1.6L - - 24lbft
Still looking for stretch limits though?
|
csweatherston
Member
Registered: 16th Jan 06
Location: Devon
User status: Offline
|
i thnik it says on the packaging.....ill have a look for it in a while.
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
bump
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
The stretch limits are only relevant if you re-use them. You MUST measure them before first use though otherwise it is pointless.
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
Yeah I'm re-using them. Found the info on the arp website, should have checked there first really 
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
You are re-using them? So you have used them once already? If you didn't measure them before use then getting the figures now are useless.
For the sake of £60 or so you may as well replace them now.
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
I measured them before I installed them, and they are fine.
I'm not keen on using them, but cant justify £60 on bolts when im skint and at uni.
They aren't going to see much use, its only for the sake of getting the engine back together so i'll be safe enough.
|
