grogan
Member
Registered: 31st Jul 06
Location: County Durham
User status: Offline
|
.. on a C20XE.
What would you lot go for (can only afford one or the other at the moment)
A. Full system & induction kit
OR
B. Cams (if so which ones>
Any other suggestions welcome....
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
Cams without remap = hardly anything
Full system + ind kit = Few bhp, better revving at top end etc.
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
This in a Corsa?
If you fit an induction kit to the XE make sure its Enclosed like a Viper or BMC as low speed driving the car will stutter with the heat (common on XE's)
PowerCaps apparently move the torque band a bit further up the rev range and they increase the induction roar but dont believe eveything you hear about bhp increases with them things.
Full System should free up a few ponies and free up the revs.
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Id go for a full system.
Ditch the induction kit, fit a free flowing panel filter in the air box.
Cams are a bit pointless on the standard inlet/ecu etc.
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
BMC CDA or K&N apollo are good ind kits, enclosed so keep the heat out better than the airbox and have bigger surface area than the panel filter.
|
grogan
Member
Registered: 31st Jul 06
Location: County Durham
User status: Offline
|
thanks for the advice guys, think i will go for a full system & a BMC CDA!
|
