jez hall
Member
Registered: 14th Aug 06
Location: leeds
User status: Offline
|
HELP my fekin x16xe is pushin oil out from camcover i checked both crank- camcover breathers an there ok an the little camcover-inlet breather is clear.
it pushes oil out from camshft oil seals an camcover its really buggin me is there more breathers???? or has anyone had this problem befor if so any suggestions welcome thankyou.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
remove and refit the cam seals, only 3 quid each. as for the cam gasket replace that as well. make sure you tighten the cam cover bolts up in the correct sequence and to the correct tightness, so many people over/under tighten them in the wrong sequence!
remember to put a smear of hermatite red in the correct places as well, mainly against the end cam bearing caps where they meets the head, ensuring not to block the oilways.
|
jez hall
Member
Registered: 14th Aug 06
Location: leeds
User status: Offline
|
did all that except the red hermatite an wots the tightenin sequence 4 the camcover
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
best to buy a haynes manual
|
jez hall
Member
Registered: 14th Aug 06
Location: leeds
User status: Offline
|
got it on disc lol
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
just tighten each bolt bit by bit, too 8nm, which is hand tight a LITTLE nip if you dont have a torque wench
and we normaly use black sealant on the end caps
[Edited on 17-09-2006 by warren.g]
|
