Stoneyginger
Premium Member
Registered: 25th Jan 01
Location: Stonehaven, Aberdeenshire
User status: Offline
|
Having some trouble with the corsa, when running it drops power and comes straight back, pulling away it jerks like a kangaroo can't explain it. Water was leaking from the header tank onto a junction box of some kind below it but i have sorted this leak but the problem has not gone away. The left hand driveshaft knuckle is going also so not sure if it is possible its just this. Can't understand what is going on, just feels like the engine loses power for split seconds then comes back a lot!. any ideas? Also Finally it has started stalling on idle as well!
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
icv air flow metre cranksensor??
any codes?
whats condition of dizzy and rotor arm like
[Edited on 11-07-2006 by J100RSA]
|
Stoneyginger
Premium Member
Registered: 25th Jan 01
Location: Stonehaven, Aberdeenshire
User status: Offline
|
no codes popping up at all, air flow meter is pressed in after i fitted the strut brace the wires are tight with the metal. might try taking the strut brace off and freeing the Air Flow meter off a bit. ICV havnt touched that yet crank sensor havn't looked at that yet either. Throwing no codes at all
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
check dizzy cap and arm 1st that the easyest and the cheapest
|
Stoneyginger
Premium Member
Registered: 25th Jan 01
Location: Stonehaven, Aberdeenshire
User status: Offline
|
check it as in make sure the connections are ok? take the dizzy cap off and clean it up?
|
Ryan_G1
Member
Registered: 29th Aug 05
Location: East Ayrshire
User status: Offline
|
Does it do it when its cold?
|
Stoneyginger
Premium Member
Registered: 25th Jan 01
Location: Stonehaven, Aberdeenshire
User status: Offline
|
Sorted!!. Took the strut brace off and repositioned the AFM then put the strut brace back on better fit and that car ran fine thank god!!!!
|