russb 
Member 
 
Registered: 30th Oct 04
 Location: chester-ish 
User status: Offline 
 
 | 
 
My Fault codes!!! 
 
12-Initiation of diagnosis. 
85-Immobiliser Wrong signal  
43-Primary ignition (distributor systems) High voltage  
84-Immobiliser No signal  
56-Air control soleniod Low voltage  
63-63 Amplifier control signal, cylinders 2 and 3 (Direct Ignition System (DIS)) Low voltage  
64-64 Amplifier control signal, cylinders 1 and 4 (Direct Ignition System (DIS)) Low voltage  
29-Fuel pump relay Low voltage  
92-Camshaft sensor Faulty hall effect sensor or circuit  
93-Quad drive module (in ECU) 
35-Idle stepper motor Poor or no idle speed control  
19-Crank Angle Sensor (CAS) Incorrect RPM signal  
34-Manifold Absolute Pressure (MAP) sensor Low voltage  
15- Coolant Temperature Sensor (CTS) High voltage  
 
 
now is it me or is it very unlikly that they have all broke? considering i have bought BRAND NEW sensors - CTS,CAS,CSS, i think i need to get an ECU  
 | 
James R 
Member 
 
Registered: 4th Feb 03
 Location: 205GTi16/306GTi16 
User status: Offline 
 
 | 
 
Take it to a local ECU test centre andget them to run a diag on it's £40, could also be the loom though mind.
 | 
corb 
Member 
 
Registered: 24th Apr 02
 Location: Calgary, Alberta, Canada 
User status: Offline 
 
 | 
 
have you re-set your ECU?? If its buggered, it normally knows it and has a fault code for a fucked ECU, as I had this   . Disconnect you battery for an hour or so, should reset the ECU.
 | 
russb 
Member 
 
Registered: 30th Oct 04
 Location: chester-ish 
User status: Offline 
 
 | 
 
the battery has been disconnected for 3 days  
 | 
russb 
Member 
 
Registered: 30th Oct 04
 Location: chester-ish 
User status: Offline 
 
 | 
 
but even before it was disconnected, i did get alot of random fault codes, thats why i have loads of new sensors, i gave up after a while coz the codes where staying there!!
 | 
russb 
Member 
 
Registered: 30th Oct 04
 Location: chester-ish 
User status: Offline 
 
 | 
 
what could be up with the loom?
 | 
corb 
Member 
 
Registered: 24th Apr 02
 Location: Calgary, Alberta, Canada 
User status: Offline 
 
 | 
 
You're not getting damp onto the ECU are you? mine did this, was running down the loom into the footwell. Kept chucking all sorts of fault codes at me.
 | 
calidus 
Member 
 
Registered: 27th Oct 02
 Location: Lincoln 
User status: Offline 
 
 | 
 
yer i had the dampness problem, take ecu out n check the pins?
 | 
Kerry 
Member 
 
Registered: 5th Oct 01
 Location: Norwich 
User status: Offline 
 
 | 
 
i had a similar problem and it turned out all the connections in my fuse box had gone green as the car was once stood a long time. cleaned all the connections up and it was fine after that
 |