|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » SETTING UP GEAR LINKAGE C20XE » Post Reply
|
dalejones |
posted on 8th Nov 10 at 10:40 |
hmm my box doesnt seem to have the pin with the spring on it! how else will i set it to nenutral? | |
markx14xe |
posted on 6th Nov 10 at 18:52 |
i found pinning the gear stick in the car to the left was to far over and was causing problems so, i made sure it was in the middle while i pin the linkage in place under the car tighten it all up now have all of mygears and reverse :) | |
alan-g-w |
posted on 6th Nov 10 at 10:36 |
this might help mate http://www.corsasport.co.uk/board/viewthread.php?tid=522108 | |
dalejones |
posted on 6th Nov 10 at 10:15 |
hmmm quite unsure wot u mean, the pin that holds the linkage to the gearbox bit? | |
nad123 |
posted on 6th Nov 10 at 03:37 |
You need to twist the linkage coming out the box until the little pin with a spring on the gearbox presses in | |
dalejones |
posted on 6th Nov 10 at 03:12 |
got all the engine in (c20xe corsa) and the linkage is all in place on the gearbox just need to attatch it to the car, just need to know how do you know when the gearbox is in neutral? so i can get in the car, put the selector into neutal and tighten up the bolt?? |