Rad666
Member
Registered: 9th Jun 06
Location: North Yorkshire
User status: Offline
|
Black Wires x4 (immobilisation wires)
- identified as a loop, by a tape or band at the ends
For correct operation, at least one of the immobilisation circuits must be ignition live and live while cranking.
Cut each circuit to be controlled (check current rating if in doubt) and then form an immobiliser circuit by
simply cutting each wire loop. Connect one end of the cut wire loop to each end of the circuit you wish to
isolate - polarity is not important. DO NOT MAKE IMMOBILISER CONNECTIONS TO THE NEGATIVE SIDE OF THE IGNITION
COIL. Re-tape the harness so that the immobiliser connection points are difficult to identify. Do not make
connections at places that a thief could easily identify or access i.e. do not make any connections close to the
ignition barrel or in the engine bay next to the ignition coil.
Note it is not possible to immobilise a permanent 12V supply
this is what is say in the instructions, any ideas???
Also Green Wire (negative door circuit)
Connect to a door light circuit that goes to ground when any door is open. If required fit additional pin
switches or connect existing door circuits together (inserting diodes if necessary) to ensure correct operation.
of both the alarm and interior light.
Yellow Wire (positive door circuit)
Connect to a door light circuit that goes to +12v when any door is open. If required fit additional pin switches
or connect existing door circuits together (inserting diodes if necessary) to ensure correct operation. Interior
light illumination is not available from this wire.
there is only one wire
need help a.s.a.p thanks
|
Cossie
Member
Registered: 17th May 02
User status: Offline
|
the first four black wires you need to put them a pair of wires on ignition (red wire) connection and the other pair you can put them on fuel pump (find positive wire on ignition to pump) , interior light you need no diode as the grey wire is gound wire you can just add the green wire with this grey wire
|
Rad666
Member
Registered: 9th Jun 06
Location: North Yorkshire
User status: Offline
|
cheers mate any one else got advice or anything a avnt got a clue where the ignithion wire is pics would be helpful
|
