fudleone
Member
Registered: 22nd May 05
Location: Isleworth, Greater London
User status: Offline
|
Hey guys,
these are the lights i have: Lights
now the lights have 4 holes for bulbs. for the middle bit, do i need a two in one jobbie?
the wires for each bulb holder are different. i dont have instructions, anyone have ideas which one is for which compartment?
cheers,
Fudleone
[Edited on 10-01-2006 by fudleone]
|
Rus
Member
Registered: 24th Jan 05
Location: SE London, Kent
User status: Offline
|
i took mine to halfords and they got all the right bulbs and put them in the right holes. or just get someone to push the brake and you go through them till on lights up?
|
andybill
Member
Registered: 17th Oct 05
Location: derby
User status: Offline
|
the bulb holders gve it away which one needs a dual filament and which needs a single with the amount on *scuse the expression* knobs inside. other than that i think the only bulb that needs to be coloured is the indicators so stick hazards on and find which ones they are . hope this helps 
|
CorsAsh
Member
Registered: 19th Apr 02
Location: Munich
User status: Offline
|
Black/Red/Green wired holder is for dual filament side/stoplight, goes in the top hole.
Yellow/Black wired holder is for indicator, goes in one of the middle holes
White/Black is reverse light, goes in the remaining middle hole.
Blue/Black is high intensity rear, and goes in the bottom hole.
|
fudleone
Member
Registered: 22nd May 05
Location: Isleworth, Greater London
User status: Offline
|
thanks guys, i looked at it again and it does say on the back of the lights......now i can drive to specsavers.
what u think of those silver indicator jobbies? need them in offset pin to fit the indicator holder.
Thanks again,
Fudleone
|
