Wrighty
Member
Registered: 28th Feb 04
Location: Howden
User status: Offline
|
fitted lockwoods yesterday
speedo needle popped off,bugger! put it back to 0 and when i start the car it goes down to 6 o clock (bottom of dial)
also rev needle didnt come off,but its not showing correct revs
before it used to idle at just under 1k revs,now it shows near 0rpm
just a case of trail and error gettin them back to normal?
|
Chris_Sport
Member
Registered: 6th Jan 05
Location: Barrow In Furness
User status: Offline
|
Fit them while the engine is running and you're stationary. Should be able to get them near enough on.
|
Wrighty
Member
Registered: 28th Feb 04
Location: Howden
User status: Offline
|
am i alrite taking rev needle off?
speedo one shouldnt be a problem
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Offline
|
Are they moving correctly but misaligned, or not moving correctly?
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
i take it there electric, ie not cable driven
in that case i have 2 sets 1 reading 22k and one reading 48k
both for sale 
|
Wrighty
Member
Registered: 28th Feb 04
Location: Howden
User status: Offline
|
not sure about speedo moving correct,as its sat in the garage sorned,but iv taken the needle off and put it back on where its meant to be so looks ok
revs is moving fine but its misalinged itself? yet its not been off,reading just under what it should,so iv taken it off n shall put it back on properly when i next run the car
il sort it out,somehow 
|
