j7 gkk
Member
Registered: 16th Jun 05
Location: Sheffield
User status: Offline
|
take your plastic trims off the rear, and get a hammer lump one is the best i found and flair your arches best off hitting all the way around your arch instead of one place, then under where the holes for you trims mount, draw a line all the way round about 3mm off the holes and use a buzz saw or grinder to cut it away, when youve done this you must either paint or seal the edges to stop them rusting/corroding, then with your plastic trim draw on the edge of this and buzzsaw this away, and instead of using your clips justt apply sealer to the trim but becareful of sealer getting all over the place, hope this helps mate its what i did, and your frnt one wont need doing, only thing on the front youll ahve to becareful of is the anti roll bar
|
