mobymaster
Member
Registered: 12th Sep 04
Location: Rawtenstall, Lancashire
User status: Offline
|
Basically, i shut the bonnet, drove down the road, attempted to pull the leaver inside, and it was really loose. tried again and nothing, went to try to pull bonnet up and nothing happened.
Ive tried the pressing in the middle while someone is pulling, been messing around for about 4 hours, just wondering if anyone has any ideas before i take it to the garage in the morning.
|
MR2Mike
Member
Registered: 20th Jan 05
Location: Old Trafford. Drives: MR2 N/A
User status: Offline
|
must have snapped the cable mate
|
mobymaster
Member
Registered: 12th Sep 04
Location: Rawtenstall, Lancashire
User status: Offline
|
Garage jobby then?
How much roguhly so i know if the guy is tryna rape me or not on price.
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
I've opened them in the past by using a long piece of metal rod, slide it in behind the grill, so that it pushes where the lever pulls, and presto, a popped bonnet, then to adjust the cable, there's a X head srew with a clip on it to hold the cable, undo this a little and pull the cable taught, and do it up again, and magically the lever is now taught 
|
MR2Mike
Member
Registered: 20th Jan 05
Location: Old Trafford. Drives: MR2 N/A
User status: Offline
|
its a garage job yeh mate but shouldnt b too expensive i dnt think 
|
Dave
Member
Registered: 26th Feb 01
Location: Lancs
User status: Offline
|
You can get to the release from underneath and pull it open with a set of grips.
Do a search on here.
|
