OliSteadman
Member
Registered: 14th Oct 07
Location: Barnsley
User status: Offline
|
x16xe engine, x16xe clocks (electronic) 1.48v shell. Coming off the tranducer from the gearbox are 3 wires:
1 brown
1 black
1 blue and red
Where do these wires go to make the speedo and rev gauge work?
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
They are just for the speedo
|
OliSteadman
Member
Registered: 14th Oct 07
Location: Barnsley
User status: Offline
|
Yes i know this but where do they go any1 know.
Im i right in thinkin that the green wire isthe revs? if so where does this get wired into?
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
green is revs iirc yeah
i think they all got to the back of the clocks
|
Nic Barnes
Member
Registered: 5th Apr 04
Location: nowhere near ginger people
User status: Offline
|
green is rpm
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
Green from the ECU is the rpm signal. Were the clocks in the shell electronic before you put this gearbox in? If they were then there will be a little round connector which goes onto it.
The wire colour are:
brown - earth
black - Ignition live
blue/red - Speed signal
I converted mine to electronic and connected all 3 wires to the back of the clocks. Without the RPM signal you will cut out everytime you roll up to a junction with the clutch down 
[Edited on 29-11-2007 by luke85]
|
OliSteadman
Member
Registered: 14th Oct 07
Location: Barnsley
User status: Offline
|
No the shell wasnt electronic b4 was cable driven. Ye was wonderin why i was havin the problem of the car cutting out, only does it sometimes tho not always.
Cheers
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
just wondering, If it was cable before why are you converting it to electronic drive? the cable should just screw into the new gearbox the same
[Edited on 29-11-2007 by luke85]
|
OliSteadman
Member
Registered: 14th Oct 07
Location: Barnsley
User status: Offline
|
no it was an 1.4 single point injection (M reg) and now has the x16xe in it and gearbox so i obviously got the clocks as well.
|
