jmdsouth
Member
Registered: 11th Feb 03
User status: Offline
|
hi ive got a 1.4 16v 97 P reg corsa sport it started spluttering today and started missfiring, cutting out etc so limped home just about and did paperclip test flashed 10 times then once then 10 again then 5 times and which is 0105 right? i then tried it with the engine running and it just contioulsy flashed without any pauses? anyways 0105 is Intake manifold pressure sensor which is just to the left of the coolant bottle with a green clip right? i checked the clip was pushed in properly then took it for a drive started missfiring slightly but not seems to run ok but doesn't idle that well the ecu light stays on as well whilst driving, sorry for the essay! but what else can i do? or is it just a case of getting a new Intake manifold pressure sensor fitted? thanks.  
|
graham16v
Member
Registered: 21st Jun 06
Location: Near Heathrow Airport, Middlesex
User status: Offline
|
Check the vacuum pipe for any leaks.
|
jmdsouth
Member
Registered: 11th Feb 03
User status: Offline
|
i brought a new vacuum pipe for it but no joy so going to have to change the sensor next, just watch the ecu light stay on when the new sensor is put on!
|
cor5a_tommy
Member
Registered: 31st Jan 07
User status: Offline
|
I got stuck 230miles from home with that issues and after putting a new MAP sensor on it was fine...cost nothing at the scrap heap because they didnt know what it was so couldnt charge...if you need a map sensor send me your address via U2u and i will fire it to you in the post FOC because i have a spare
|
jmdsouth
Member
Registered: 11th Feb 03
User status: Offline
|
it was one of the 3 wires on the plug that go into the sensor! it had snapped! got a new plug and used some crips to put the wires back and hey presto no more ecu light!
|
