Jake
Member
Registered: 24th Jan 05
User status: Offline
|
got a legacy la890 amp with 2x12 subs approx 300Wrms each - 8gauge power cable with 4 gauge earth cable.
Yesterday happily driving along with the volume on fairly low and noticed that there was no bass, pulled into a carpark and looked to see if the protection light came on - there were no lights on at all. Fiddled around with the wires later on, still didnt work so tried another amp and it worked, put the legacy back in and it worked straight away, no problems. Pulled out of work tonight and everything was ok, then the amp just cut out again, checked it and no lights are on. Can't be a power cable problem because ive had it installed for about 5months with NO issues
any ideas?
[Edited on 01-10-2005 by jake]
|
chr15barn3s
Member
Registered: 5th Oct 03
Location: Farnborough
User status: Offline
|
Dodgy earth or remote i would think, just a guess though
|
MR2Mike
Member
Registered: 20th Jan 05
Location: Old Trafford. Drives: MR2 N/A
User status: Offline
|
earth cable bud, deffo
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
ill swap earths and get back to you but as i said its had the same cables and earth for around 5 months with no issues.
[Edited on 02-10-2005 by jake]
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
replaced earth and not a dicky. Wired up the test amp and it worked fine. Wired the legacy back in and everything works ok, its like the cables need a jump start or something
|
Wrighty
Member
Registered: 28th Feb 04
Location: Howden
User status: Offline
|
checked the remote wire from hu mate?
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
i did check the connection at the back of HU and it seemed ok but it may need soldering as its just been connected by electrical tape.
|
Martin
Member
Registered: 15th Mar 04
Location: Dumpstable Drives: Aztec Sxi
User status: Offline
|
have you tried legacy amp up againt OTHER drivers? get any probs wit that?
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
what you mean drivers?
|
Martin
Member
Registered: 15th Mar 04
Location: Dumpstable Drives: Aztec Sxi
User status: Offline
|
gettin confused with another thread.
have u tried your amp againt other subs?
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
no, dont know anyone else with subs
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
grrr. It has been fine up until last thursday when it cut out again. I cant think what it could be. Ive disconnected and reconnected the wires and it still wont turn on.
|