Darren
Member
Registered: 21st Apr 02
Location: Hadleigh, Suffolk
User status: Offline
|
Hi ive fitted and wired up my leather seats  outa a calibra but the drivers side doesnt work, it doesnt get hot at all,  ive checked all the wiring and its ok...
Is it possible to pull the seat appart and maybe repcae the heat mat? If so its this a big job?? 
cheers 
|
MattyB
Member
Registered: 13th Nov 01
Location: 118.5bhp :D
User status: Offline
|
Check the wire on the driver seat, where it passes between the bottom cusion and the back rest, they are prone to gettin cut by the seat mechanism there.
|
Darren
Member
Registered: 21st Apr 02
Location: Hadleigh, Suffolk
User status: Offline
|
Matty, tried that, the wire seems totally intact all way into seat. Ive tried pulling the wires a bit and they dnt come off so im guessing they are connected to theheat mat ok so all i can think is the heat mat is dead....
|
MattyB
Member
Registered: 13th Nov 01
Location: 118.5bhp :D
User status: Offline
|
yup dead mat then mate, my set were the same.........
might be a bit of a mission to get the mat out tho....might need an upholstorer or summat......
Matt
|
Darren
Member
Registered: 21st Apr 02
Location: Hadleigh, Suffolk
User status: Offline
|
ok cheers mate
|
