|
|
|
Not logged in [Login - Register] |
 |
You Are Not Registered Or Not Logged In |
|  |
|
Corsa Sport » Message Board » General Chat » Been a while.. Z16ler in b advice needed. » Post Reply
|
| Robin |
posted on 9th Apr 13 at 07:45 |
X18XE1 is small block, X18XE is not | |
| tobyc20xe |
posted on 9th Apr 13 at 07:19 |
quote: this! the x18xe is aslo a small block engine and cabel throttle so could be used. were as the Z18xe was fly by wire. pritty sure the x18xe1 or L i think it is was aslo a small block engine you can use the throttle body off to. i remenber a few years back on here a lad had a white B and he did this engine conversion,maybe spend some time looking for it in project's. | |
| IvIarkgraham |
posted on 9th Apr 13 at 01:24 |
if ive got the correct engine then yes | |
| johnny86 |
posted on 8th Apr 13 at 22:11 |
Thanks mate and that will fit on to the vxr engine? | |
| IvIarkgraham |
posted on 8th Apr 13 at 21:58 |
x18xe throttle body conversion iirc | |
| johnny86 |
posted on 8th Apr 13 at 21:55 |
Ok cheers mate, what's the best way to get rid of it? | |
| tobyc20xe |
posted on 8th Apr 13 at 21:49 |
fly by wire is fucking shit! do away with it at all cost's,nothing but shit throttle response also if you off and on the throttle it get's comfussed. | |
| johnny86 |
posted on 8th Apr 13 at 21:43 |
Is there not away I can keep it fly by wire? It's cost me £1200 for engine mounts and shafts to be made so don't mind bit of extra money to spend. | |
| davegreen |
posted on 8th Apr 13 at 21:38 |
try contacting ecu manufactures to start with, as the z16let/h engines are fly by wire the simplest way round this is to swap to cable throttle. also speak to engine builders and tunners. simple to fit if you can find a kit. going stand alone means you can do away with alot of the engines sensors and make it simple. | |
| johnny86 |
posted on 8th Apr 13 at 21:28 |
Right it's been a while guys, I've got a black sport I'm turning into a track car. I am fitting a complete corsa vxr engine and box. Before any sarky comments I can get the mounts and shafts made to fit. I'm a bit confused about stand alone management I understand they use these engines in kit cars but its a pain sake finding some one who can help fit it. Also where can I get a cage built in Kent area? Thanks guys. :thumbs::thumbs: |