|
sri boy
|
posted on 3rd Jan 11 at 16:15 |
they ususaly knock out and press back in with some persuasion bud
|
chris_uk
|
posted on 3rd Jan 11 at 16:12 |
i cant imagine that it would cost a lot for the engineering place to do really.
|
davieslim
|
posted on 3rd Jan 11 at 16:10 |
always had any of mines done at a local engineering shop as im sure the head needs heated up to push the old ones out then the new ones pressed in and the head cooled down
well i think thats how its done
|
chris_uk
|
posted on 3rd Jan 11 at 16:07 |
should be buying a head off a lad on ebay, says the inlet valves were replaced due to a snapped chain, he says hes checked the valve guides and they were alright but im thinking worst case senario..
i was thinking about replacing all 16 valve guides and wondered how hard they where to do.
|