|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » General Chat » X16XE Turbo » Post Reply
|
Vaux Lad |
posted on 22nd Dec 07 at 17:13 |
Ideally you want a custom set made by someone like CatCams. | |
Cossie |
posted on 22nd Dec 07 at 17:03 |
From what I have read as i am searching out to do a conversion myself too the short duration cam like 256 and 265 are good but not 270 and up profiles ! | |
Vaux Lad |
posted on 22nd Dec 07 at 12:56 |
You'll need a fully mappable system for a turbo, not a remap. | |
csweatherston |
posted on 22nd Dec 07 at 10:51 |
as said, it should be 150ish there now.. | |
gavin18787 |
posted on 22nd Dec 07 at 10:22 |
that spec there I would have said would be 140-150ish bhp anyway. | |
eastend |
posted on 21st Dec 07 at 22:54 |
if the x16xe is set up as follows before getting the turbo kit, what would still be used and what would be replaced or not required? | |
eastend |
posted on 21st Dec 07 at 22:50 |
thats where im struggling :lol:, have other plans for car first of all but maybe in a years time i could go down this route, definately something i want to do | |
sand-eel |
posted on 21st Dec 07 at 22:39 |
if you have the cash.....do it | |
willhouse |
posted on 21st Dec 07 at 22:37 |
plus the time on the rollers to get a full custom proper map which is going to be a bare minimum of £500+ depending on where you go. | |
sand-eel |
posted on 21st Dec 07 at 22:34 |
engine £200-300 | |
willhouse |
posted on 21st Dec 07 at 22:27 |
there was a thread about this the other day, | |
eastend |
posted on 21st Dec 07 at 22:14 |
:D thats what i like to hear, i know they are going to be expensive? but how much cost wise to acheive 200bhp? | |
sand-eel |
posted on 21st Dec 07 at 22:12 |
probably about 150bhp but well over 200bhp can be acheived. | |
eastend |
posted on 21st Dec 07 at 22:04 |
I know all the issues with the compression ratio being so high but that can be sorted. |