|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Regional Groups & Events » North East » spare wheel well » Post Reply
|
Alex_Rally |
posted on 23rd Mar 11 at 06:16 |
flat sheet of metal mate then strap your spare wheel in the rear of car :) | |
brebaz |
posted on 22nd Mar 11 at 23:12 |
Go to the scrappy look for a good nick one cut it out and operate on your ;) | |
Mieran |
posted on 21st Mar 11 at 22:20 |
Cut the well out and plate it with a flat sheet of steel then | |
Jabba |
posted on 21st Mar 11 at 22:14 |
the thing is tho they whole well would need plating as the holes are quite big and the wells weak wich is realy weerd as the rest of the car is fine nice and strong | |
john_redtop |
posted on 21st Mar 11 at 22:14 |
as said just cut out the knackerd bits with a grinder and weld some new bits in | |
Mieran |
posted on 21st Mar 11 at 22:11 |
Plate the holes is the easiest option, removing the whole well and plating it is a bit more work | |
Jabba |
posted on 21st Mar 11 at 22:08 |
today i went to take the bungs out of the spare wheel well beacuse i was gona sand the little spot of rust down and primer it but when i took the bung out quite abit of the well came out with it and it did with all 4 bungs |