|
|
|
Not logged in [Login - Register] |
 |
You Are Not Registered Or Not Logged In |
|  |
|
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Fitting new seats... HELP » Post Reply
|
| neiliosxi |
posted on 14th Oct 03 at 08:02 |
cool, would be a bit uncomfortable for ppl sitting in the back like! lol | |
| GAVINO BAMBINO |
 posted on 13th Oct 03 at 21:09 |
If you have harnesses they attach where the standard seatbelts usually do appart from the shoulder straps that attach to where the rear seat belt clips are held in place underneath the rear set, if you pull it up youl see where i mean. in exactly the same position as the pic above that adam put up. Its pretty straight forward. If you have a rear strutt brace like adam then you can just loop the harness round that without having to bolt them down. If i knew how to put pics up id show ye. As for not having harnesses all i did as a temporary measure was take out my rear seat belt clips and bolt them to the side of the subframe, on mine the bolts for this were already there. Hope this helps. Gav | |
| Adam-D |
posted on 13th Oct 03 at 20:46 |
quote: they attach to bolt on left and right of seat where ur old seat belt is and at the back seat seatbelt position  the strut brace is in the way but you get the idea | |
| a7syp |
posted on 13th Oct 03 at 20:21 |
Just the question i was about to ask? Anybody help us out? :) | |
| neiliosxi |
posted on 13th Oct 03 at 11:32 |
if u use harnesses wot do they attach to? | |
| a7syp |
posted on 13th Oct 03 at 10:30 |
Thanks guy's, im gonna have a go today!! :o Gav, ive not got harnesses yet, but was planning on getting some in the future! | |
| GAVINO BAMBINO |
posted on 9th Oct 03 at 16:54 |
I fitted some cobra monocos to my corsa bout 6 months ago. All you need to do is remove the plastic next to your seat near the door and you will see some kind of cannister, you will also see what looks like a red key, this needs to be put in the slot on top of the cannister there are instructions written on the top. You then need to get an ET40 or ET45 star spanner and undo the two bolts at the back of the seat, the seat should then just slide out of the slots at the front and hey presto, one seat out, do the same to the other side. To fit your new seats simply screw the subframe to the seat before it goes in then bolt it in as you took it out. Do you have harnesses? if not it gets more complicated. My wording maybe a bit confusing but hope it helps. Gav | |
| drunkenfool |
posted on 9th Oct 03 at 16:31 |
buy the max power guide to modding, £20 and its got loads of tips in it including seats. ;) | |
| a7syp |
posted on 9th Oct 03 at 16:04 |
Gonna fit my new seats tomoz... but gonna need some help. Got set od Cobra Monco's with subframes. I haven't got a clue so gonna need as much advice as possible on removing old seats and fitting new ones. |