|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Powerflex bushes front tie bar to chassis information » Post Reply
|
Jed D |
posted on 1st May 12 at 20:48 |
useful crack pal :thumbs: | |
chrisn1234 |
posted on 1st May 12 at 17:14 |
reece did you need a vise or anything to press them in ? or some gentle persuation with a 4lb club hammer :D | |
Joey 1.6 sport |
posted on 1st May 12 at 14:13 |
Right just took mine out new ones from rally design one is bigger than the other and is like a dick in a bucket but there is a sleeve in there do I knock that out then fit whole bushes not half ones ? | |
reecegsi |
posted on 1st May 12 at 11:24 |
very easy to do done mine in minutes once i figured it all out about bushes:nod: | |
chrisn1234 |
posted on 1st May 12 at 08:04 |
The post 97 type has to be pressed in, its not in 2 halfs with a sleeve like the pre 97 ones i am fitting the post 97 ones over the bank holiday weekend so i will find out how hard or easy they are to get out and press in | |
jayy.cfg |
posted on 28th Apr 12 at 21:55 |
i tried to get my from polbushes off until i realised i have the pre 97 bushes, are they ment to come out easily on the late type? | |
chrisn1234 |
posted on 28th Apr 12 at 14:38 |
I have a bit of information that might help a few people, i have struggled to find information to see what the difference is between the front tie bars on the pre 97 corsas to the later post 97 ones. I have found out the following in relation to the front tie bar bushes: |