|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » C20XE coolant hoses » Post Reply
|
Darryl H |
posted on 14th Dec 11 at 12:29 |
I'm guessing it would be fine if it's been used like that before. | |
Edges 58 |
posted on 14th Dec 11 at 10:13 |
Hello... ^^^^ any answers to my question? | |
Edges 58 |
posted on 13th Dec 11 at 17:55 |
just found this thread after searching around about my coolant hoses so sorry about bringing up an old thread... | |
harvey_1066 |
posted on 21st Sep 11 at 16:48 |
yeaa i took my plug out the end of the hose tonight and blew down it and it bubbled back up in the header tank so yea thats got to be connected back up, and yea iv got both i did have the one with two but then swapped it to the one with one as didnt know where it went but now i'l have to swap it back, i'l do it now as iv found a few more problems with my engine, cracked sump so im in no rush but cheers anyway for the info very helpfull | |
Jamie-C |
posted on 20th Sep 11 at 22:28 |
One of them goes to number 1 in this pic mate, and the other goes to the header tank :thumbs: | |
Kieran |
posted on 20th Sep 11 at 21:10 |
It should go to the tank yea. If there isn't one on there ya. | |
harvey_1066 |
posted on 20th Sep 11 at 20:56 |
ah right, hmm god knows what im thinking of then, i'l have a look 2moro afternoon when i get back from work, but iv got two pipes at are joined togeather as such side by side that come from the under side of the manifold somewhere, and the one pipe is connected but dont know where the other one goes to so i plugged it up with a bolt, is this the other water pipe thats supposed to go to the header tank then? | |
Kieran |
posted on 20th Sep 11 at 20:37 |
There water cooled inlets anyway? | |
harvey_1066 |
posted on 20th Sep 11 at 17:39 |
ah right so thats where that goes? but one question water breather pipe to inlet manifold?? that doesnt sound a good mixture.... | |
Kieran |
posted on 20th Sep 11 at 12:39 |
Yea that's the one. Should have 2 pipes coming from the iirc. | |
Jamie-C |
posted on 20th Sep 11 at 12:26 |
Cheers for the info mate, think I know where it goes now, think the previous owner has plumbed it up wrong which is whats confusing me :facepalm: | |
Kieran |
posted on 20th Sep 11 at 08:44 |
The pipe your referring to Jamie that you have to the heater matrix is the water bar (Long black pipe the runs on the back of the block) | |
Kieran |
posted on 20th Sep 11 at 08:43 |
The pipe your after leads onto the back of the inlet tucked up underneath iirc. My pipe looks different to most because I hadn't been assed to tuck it back under the inlet again. Because I needed to take a few bits off. But it does go round the inlet bud. | |
Jamie-C |
posted on 19th Sep 11 at 23:16 |
No Dan I couldn't find anywhere for it to go in the area you said, starting to confuse the hell out of me now. | |
alan-g-w |
posted on 19th Sep 11 at 23:11 |
Kieran's in the first pic has had wires hidden and hoses rerouted if I'm not mistaken, quite far from standard anyway | |
DansCorsaSXi |
posted on 19th Sep 11 at 22:11 |
Take it where Ash's went yours didn't? | |
Darryl H |
posted on 19th Sep 11 at 22:02 |
Kies looks different to mine. On mine it goes to the pipe that comes round the block and the other goes to the top of the rad :boggle: | |
lee mitchell |
posted on 19th Sep 11 at 21:52 |
on the inlet manifold in the centre there will be a breather that goes to the rocker. either side of that will be 2 hoses. one goes to where u said the other goes just above the alternator | |
Jamie-C |
posted on 19th Sep 11 at 16:57 |
Left hose on the expansion bottle, goes along the bulkhead. Then where? | |
Jamie-C |
posted on 19th Sep 11 at 16:28 |
Done the plumbing on my Corsa XE, got one pipe left that I can't find where it goes, its the left outlet on the expansion bottle. I've looked all over the inlet manifold but can't find its home, can anyone shed any light? |