|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » How easy is it to take the bonnet off completely ? » Post Reply
|
Karnage Corsa |
posted on 13th Mar 03 at 20:40 |
so what tools then lads screw drivers hammer punch or something to get pin out what else cant be much more cheers | |
wainey |
posted on 13th Mar 03 at 20:08 |
quote:positive mine didnt have them, couldnt see anything that resembled a connector, where exactly is that connector, would make life easier! | |
Karnage Corsa |
posted on 13th Mar 03 at 20:07 |
thanking you might ned to read this again when I need to do it cheers lads I posted this ages ago and now all of a sudden I know what I am doing so can you tell me what tools I should need exactly lads | |
Kris TD |
posted on 13th Mar 03 at 20:05 |
if you look where the washer pipe enters the bonnet there is a connector so u can disconnect the pipe, do this then remove the washer pipes off the car, much easier. | |
wainey |
posted on 13th Mar 03 at 19:57 |
no probs :thumbs: | |
Karnage Corsa |
posted on 13th Mar 03 at 19:56 |
U HAVE MATE THANKS AT LEAST I HAVE SOME IDEA OF WHAT I AM DOING NOW THANKS VERY MUCH MATE | |
wainey |
posted on 13th Mar 03 at 19:55 |
right dad just got back, the catch is held in by a nut/bolt, not sure what size, and theres also the safety catch which is held in by a solid pin, it needs to be knocked out with a hammer and a drift (punching tool), so that u can swap this to your new bonnet, just be dead careful with the screwdriver then mate! should be ok if your careful! hope ive been of some help!;) | |
Karnage Corsa |
posted on 13th Mar 03 at 19:50 |
THANKS A LOT MATE THE BONNET IS BEING SOLD SO I CANT F!CK IT UP COS ITS IN GOOD CONDITION ANY OTHER HELP IS APPRECIATED | |
wainey |
posted on 13th Mar 03 at 19:47 |
the washer jets just pop off, the pipe runs inside the bonnet just pull it out carefully, cant quite think for sure how i got mine off, if the bonnets fcuked u might aswell just put a small flat bladed screwdriver underneath the jet and just prise it off, should come off pretty easily might still be attached to pipe so just pull it off, and as u say hinges e.t.c, cnat think how i did the bonnet catch though:boggle: ha my dad did that as i was out! when he gets back ill ask him and post it up! good luck chap! | |
Karnage Corsa |
posted on 13th Mar 03 at 19:40 |
surely someone must know | |
Karnage Corsa |
posted on 13th Mar 03 at 16:08 |
need to take old bonnet off and put new one on can someone please tell me what to do ? I realise I need to remove the air scoop take off the hinges and then its off but dont know how to take out the washer jets and pipe for them and also the catch and the spring for the bonnet cheers for any help paul.... |