|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » gettin driveshafts out?????? HELP!!! » Post Reply
|
rodders16v |
posted on 11th Mar 03 at 19:13 |
there shoud be 2big bolts holding the whole balljoint on undo them instead alot easier | |
Ashton306TD |
posted on 11th Mar 03 at 13:29 |
give up john ur corsa is screwed!! stick with the pug 205!! | |
john_sri |
posted on 11th Mar 03 at 12:06 |
yeah have taken out nolt. cheers for that mate i'll give it a go big hammer stylee!! ;) | |
d0gz_bollox |
posted on 11th Mar 03 at 11:46 |
you have taken the bolt out that holds the bottom ball joint to the hub yes? (10mm I think). Get a big bar and lever the arm down. if that doesnt work. Stick a break bar between body and arm and then jack steering knuckle up to pop it out. WD40 it. just needs a bit of abusing. lol. | |
john_sri |
posted on 11th Mar 03 at 11:28 |
yeah to be able to pull the wheel to get the drive shaft out you need to disconect the lower arm as it hold the hub and wheel in place. i can't get them to separate | |
d0gz_bollox |
posted on 11th Mar 03 at 11:18 |
you want to get the cv joint out of the gearbox? One mate pull on driveshaft whilst you lever joint against box. | |
john_sri |
posted on 11th Mar 03 at 10:47 |
right i took out the old gearbox by cheatin... havin the car up in the air so much that i could lower the gearbox so much that i could get them out of the diff. this was done cos we couldn't get the lower arm to hub joint to pup out so as the pull the drive shafts out. but it needs really to be undone now so as to put the new one in easier. |