|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » mmmmm 2 problems :S » Post Reply
|
Matt L |
posted on 12th Sep 06 at 19:42 |
put the screw in and its still the same but i think i know whats wrong with it; i just dont know how to sort it out. how to explain. rite if you take the switch off theres supposed to be a very small gap around the thing that you puch in and i think that when iv taken the vents out iv pushed them in so the switch wont go down far enough. | |
Matt L |
posted on 11th Sep 06 at 21:08 |
i think ill check it out on wednesday. | |
Planty02 |
posted on 10th Sep 06 at 22:04 |
Try replacing the screw before trying anything else - maybe pinch a screw out of one of the side pockets or somewhere | |
SHARPY |
posted on 10th Sep 06 at 20:24 |
make sure the clips that hold the heater panel on are clipped on aswell, when i did mine and the hazard switch wouldent turn off i found the panel wasnt clipped on properly | |
Matt L |
posted on 10th Sep 06 at 17:43 |
and i never did replace the screw. so its missin a screw that holds the mffd down | |
Matt L |
posted on 10th Sep 06 at 17:43 |
well the screw isnt amking any noises so i think thats fine. as for the hazard lights i havent tried anything yet. all i did was take the vent things out anf stick them back in once id changed the bulbs. | |
Planty02 |
posted on 9th Sep 06 at 23:58 |
...Also the screw should be fine as long as its not catching in the fans or anything (sounds like its not) | |
Planty02 |
posted on 9th Sep 06 at 23:55 |
I had the same problem with my hazards when i sprayed my centre panel. I know this is a bit vague but bear with cos it was a while ago but mine did it because i forgot to put 2 screws back in that held the front facia to the white plastic behind...have a look to make sure thyre in - should be brassy coloured ones - This will only have happened if you have taken the centre panel off, if you have then take it out again and check for the missing screws holding the front panel to the white plastic behind | |
SHARPY |
posted on 9th Sep 06 at 22:59 |
if you removed the heater control panel it wont be fitted back properly as my hazard switch did that when i replaced the heater bulbs ... worth a try if you've had it to bits that is | |
Matt L |
posted on 9th Sep 06 at 16:53 |
ah right cool ill try takin it out and turnin it round cheers. | |
vx.racing |
posted on 9th Sep 06 at 16:50 |
If you have taken the hazard lights plug out and put it back in then you may have put it in upside down, which will cause it to stick when you try switching it. | |
Matt L |
posted on 9th Sep 06 at 16:06 |
1) iv just swapped the bulbs in the mfd and one of the screws that holds it down fell down into the fan part. iv tried my fans on all the settings and cant hear anythin. will this be ok or will i need to get it out??? |