|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » brake lines... bias valve(s) » Post Reply
|
SyKaTurbo |
posted on 21st Apr 06 at 18:43 |
Not sure how it works on the pug but the corsa only has two outlets on the master cylinder (one front and one back) these run to the bulkhead where they both split so the line tees off into two anyway (cross front and rear opposite sides, i think). | |
Adam_B |
posted on 21st Apr 06 at 18:36 |
i will be trying this soon, heres my progress so far - | |
lee mitchell |
posted on 21st Apr 06 at 18:00 |
dont be tight. my mates running ap ones on every corner :lol: | |
Ian |
posted on 21st Apr 06 at 17:22 |
I'm sure there's some safety reason why you can't just rely on one pipe for the whole of the back of the car. | |
ed |
posted on 21st Apr 06 at 15:48 |
Depends on how the brakes are split... It could be a slightly bigger job than at first thought. | |
AK |
posted on 21st Apr 06 at 15:35 |
having a dilema with the 205... |