that will be your egr valve like mine, i get my new one at half 10 today mate then ill be sorting it out, its been playing up for about 6 months now but when they go it just packs in so my advice would be get it done soon as. bridge pin 5 and 6 on the plug in your fuse area and if the flash codes give 1405 and 0400 then that is you egr valve mate.

col,

hope you sort it too

so with my prob it could be egr valve or idle control

cheers people for all you advice. my egr valve has been on its way out for a while now so that may of kicked the bucket. im going to fit a new one then get the tech 2 to deleat any codes. also, i have a super chip to work with my mantzel, will this be affected by resetting codes and idle speed on the ecu?

thanks again peeps, and as above ill also check lekage of vacum pipes. cheers again everone :thumbs:

mine is being an ass reving from normal just under 1 to over 2 k i need to get it sorted should i see vaux

quote:

---

Originally posted by CoastalCorsa
just cured mine tonight i had my ecu plug in a vaux nothing shown they reset it to idle at 750 and they checked a few other sensors did not charge me thank god any way i was lookin at a vacuum pipe so i could tell some one where it goes an it turns out it had split so i replaced it an its been fine tonight it plugs onto the back of the engine just infront of the water bottle infact there should be two or three around that area good luck

---

i am in lancashire m8 an i know of a company called home tune apparently this guy has travelling mechanics and they are proper good here is the guys numbawho works near me maybe he has colleagues in you area but like it says home tune they come to you and they are good 07973780712 he`s called paul

they tried to sell me a new ecu first wanting around 300 + inc labour charges i told em straight to g t f

apparently the ecu can change there own settings ie if it thinks its putting to much fuel in it can programme itself to increase the amount of air it`s allowing in mine also ajusted its idle speed to 1450 so vaux changed it all back to standard

I found mine was doing it loads when I first put a pipercross induction kit in. To much heavy foot in 1st and 2nd seems to cause it to rev higher when idle.

is it possible for vauxhall to set it to 750rpm?
mine idles at 1000rpm but its constant. just want it that bit lower

just cured mine tonight i had my ecu plug in a vaux nothing shown they reset it to idle at 750 and they checked a few other sensors did not charge me thank god any way i was lookin at a vacuum pipe so i could tell some one where it goes an it turns out it had split so i replaced it an its been fine tonight it plugs onto the back of the engine just infront of the water bottle infact there should be two or three around that area good luck

ello peeps.... Just wondering if anyone on here has had the same problem as its doing my head in:mad:

I have a x16xe (corsa sport) and its fine from cold and fine when driving but now and again (Not all the time) when idling at light ect it idle's around 1400 rpm but there is no management light to tell me it could be any of the following, idle control valve, ecm, coolant temp sensor and so one.

Im just wondering if any of you guys could help.

Cheers

col:thumbs: