|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Lining up gears » Post Reply
|
tazzer-t |
posted on 13th Dec 08 at 17:29 |
Yep did it yesterday :):):) Cars back on the road lol | |
john_c20xe |
posted on 12th Dec 08 at 14:30 |
its easy peazy, line the two holes up in the cockpit with a 5mm drill bit, | |
DaveB |
posted on 12th Dec 08 at 13:38 |
quote: That guide is how Haynes manual tells you to do it, it is the best way by miles. All these 'trial and error' methods are just bollox. | |
tazzer-t |
posted on 12th Dec 08 at 10:17 |
Cheers bud i'll give that a bash shortly n see how it goes | |
Morley |
posted on 12th Dec 08 at 04:06 |
http://www.corsasport.co.uk/board/viewthread.php?tid=133496 | |
Morley |
posted on 11th Dec 08 at 17:52 |
Right I had EXACTLY the same problem mate. I just used trial and error to get it right buddy. | |
tazzer-t |
posted on 11th Dec 08 at 16:07 |
Ye i lined up the two holes with a screwdriver but just can't get reverse. My 1st gear is where reverse is, and 5th is nearly impossible to get but the rest are fine. Not sure how else to go about it because it's been adjusted a few times and reverse and 5th are the problem. How much dya reckon a garage would charge to do it..? Cheers for the replies | |
alan-g-w |
posted on 10th Dec 08 at 21:12 |
Aye, sounds pretty close to what I was saying. I'll find out for sure in the next couple of days. | |
Morley |
posted on 10th Dec 08 at 20:43 |
in that case, I THINK I know where the plug is, but I don't think it's a plug I think it's a plastic cap, and it is at the top of the gearbox, inbetween the dizzie cap and the battery tray if you look at it from directly above... just pop it off and try putting a thin screwdriver in it... that must be the right spot?!?!?!?!?! | |
alan-g-w |
posted on 10th Dec 08 at 20:20 |
The last thing you said there ^ that's the stage my mate was at when he used the method I'm talking about. | |
Morley |
posted on 10th Dec 08 at 19:47 |
You are from Lancaster too right? | |
alan-g-w |
posted on 10th Dec 08 at 17:41 |
Not entirely sure, but is there a plug somewhere that you remove then it's a case of sticking a small sized drill (or similair) into a hole within the hole, locates the doo-hicky and robert's your father's brother. | |
sand-eel |
posted on 10th Dec 08 at 13:39 |
the gear selector? | |
tazzer-t |
posted on 10th Dec 08 at 13:19 |
I've just finished putting engine in and I'm not 100% how to go about lining up the gears. Anyone got any advice please?? |