|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » RCA leads » Post Reply
|
AdiSRI |
posted on 12th Nov 04 at 20:43 |
that box looks pretty damn good, hmm i know a m8 with a single RCA hu who wats to have sub and amp.... | |
Richie |
posted on 11th Nov 04 at 22:25 |
id say get a fusion 1/2 din size line driver/controller. Turns one set of preouts into 3. 2x high passes for front and rear, and a sub out | |
Dom |
posted on 11th Nov 04 at 22:17 |
quote: if you only have a 1set of preouts from your HU mate, then i would invest in a line driver (thinks thats the name) where it takes in one input, and splits into X outputs - but also increases the gain on those X outputs to keep the signal as strong as poss for the amp :thumbs: like adi said, using a splitter or one of those ^ jobbies, means that you wont beable to use fader/balance controls. Only way to avoid this is to replace the HU etc :thumbs: | |
mrpbailey |
posted on 11th Nov 04 at 22:03 |
but can i not bridge it all onto the speaker outputs from 1 of the RCA things? wot effevct will that have? | |
AdiSRI |
posted on 11th Nov 04 at 19:03 |
no u need a hu with 3 pre outs really, otherwise all the speakers will play the signal from whichever output u use on the hu. | |
neiliosxi |
posted on 11th Nov 04 at 18:51 |
ideally u need a headunit with 3 preouts, but if u are only running 4 channels then u can use a y splitter. get 1 off ebay for £1 | |
mrpbailey |
posted on 11th Nov 04 at 18:47 |
its confusing cos its up to 6 channel | |
neiliosxi |
posted on 11th Nov 04 at 18:40 |
1 could be a line out mate, u should have 2 sets to a 4 channel amp, the splitters rnt the best way to go but can be used. | |
mrpbailey |
posted on 11th Nov 04 at 18:31 |
my 1100W amp has 3 lots of holes for RCA leads, but i only have 1 set. When i wire it up i can only get power to the speakers that my rca's r plugged into, say the sub............ do i need RCA cables that split off into 3 sets or is there a special way of wiring it up? |