some can confirm what i can do cause i have a set of eletronic clock at good price in my hand

the green wire is already connected or is not the same one?

Just need the correct transducer for the clocks. You screw that in place on the top of the gearbox where the old cable screwed on. You should have a green wire floating around at the back of your dash somehwere, this just needs to be soldered onto the loom you need to attatch, all the other wires just get colour matched... (You need to cut off the plug on behind your dash and attatch the plug off of the new dash - always try and solder the connections, its annoying when your speedo quits on you)

the sensor just plugs where the manual cable stays and also i found 3 cables ready for the distance sensor but i still have doughts if it works, the rev counter just need the green wire which i checked and it is there

[Edited on 05-10-2004 by Cossie]

If you have a cable driven speedo then you'd have to take apart your gearbox to change the sensor over. Im not sure about the rev counter tho.

i have a diesel man ! but still i work if i have diesel eletronic clocks no wiring needed ?

ya need an SRI or GSI set of clocks dude

i want to change my cable clock to rev counter one but all i found where eletronic clocks could it possible to use the eletronic ones. i have found the distance transmiter do they work if i simply plug it on the gearbox?:rolleyes:

[Edited on 04-10-2004 by Cossie]