|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Exhasust clearance » Post Reply
|
CorsAsh |
posted on 14th Mar 04 at 19:25 |
^^ yeah, loosen the clamp that joins the backbox to centre, and rotate the backbox - this will raise/lower the bend, so just adjust it til it clears the rear axle more. Geta mate to hold the exhaust in place, and then tighten up the clamp again. Job done. | |
AdiSRI |
posted on 14th Mar 04 at 18:55 |
twist it | |
MJ |
posted on 14th Mar 04 at 18:48 |
i have the same problem with my sebring backbox and striaght tho pipe, but only when i have people in the back. how can i sort this out. | |
fd_morph |
posted on 14th Mar 04 at 16:34 |
Yeah come to mention it the pipe does look as if it is hanging a bit low from the chassis, I shall point this out to them and we'll see what they say. Cheers | |
LukeGSi |
posted on 14th Mar 04 at 10:24 |
quote: :| they pulling your pisser mate!! Simply a case of slightly bending the pipe to clear axle or change the backbox rubbers!! :thumbs: | |
nikdegreek |
posted on 14th Mar 04 at 10:15 |
Mines exactly the same as well. Took it to garage and they said it was quite a big job. So think i will just get a new system. Any suggestion? | |
antz1 |
posted on 14th Mar 04 at 09:50 |
ive got the same prob but mines rubin ot tho coz its lowerd 60mm, just take 2 an zorst garage and they will bend the pipe | |
fd_morph |
posted on 14th Mar 04 at 09:48 |
Summary : I took my car to my local Halfords garage + had mot/service done. One thing to be done was replace my middle exhaust pipe(on Corsa B 1.2 16v). |