mark_gsi
Member
Registered: 1st Nov 03
Location: Peterlee/darlington
User status: Offline
|
Got some callly leather out of a R-plate 2.5 v6 to go in my corsa gsi. what do i need to swap over apart from the front subframes. what about the rear top half of the bench it wont fit? the bottom bench aint to bad. me and my mate had a go but just dont have a clue. any help would be great . cheers mark 
[Edited on 03-11-2007 by mark_gsi]
|
Ben ev
Member
Registered: 23rd Oct 05
Location: kingslynn / torquay
User status: Offline
|
swap the metal frame over to the corsa one. its easy to do
|
mark_gsi
Member
Registered: 1st Nov 03
Location: Peterlee/darlington
User status: Offline
|
metal frame ??? the rear benches have to be swaped dont they?
|
ad-sport
Member
Registered: 16th May 07
User status: Offline
|
if you have a split rear back rest you just fit the foam and leather onto the metal frames if not you need to go and get a split seat mate
|
mark_gsi
Member
Registered: 1st Nov 03
Location: Peterlee/darlington
User status: Offline
|
ive got a long seat frame just one piece. but ive swaped the back benches over now they just need fittin propperly. just the fronts to do now.
|
Ben ev
Member
Registered: 23rd Oct 05
Location: kingslynn / torquay
User status: Offline
|
quote:
Originally posted by ad-sport
if you have a split rear back rest you just fit the foam and leather onto the metal frames if not you need to go and get a split seat mate
rubbish. mine fitted to the one peice frame no problem. tbh i didnt know the corsa's had a split frame.
bench will be fine as wedges in surprisingly well
|
mark_gsi
Member
Registered: 1st Nov 03
Location: Peterlee/darlington
User status: Offline
|
yea mine has fit on the single piece bench aswell. was a fcuk on btu finaly did it. just the front now. any one connected the heated bit up so that works??
|
Ben ev
Member
Registered: 23rd Oct 05
Location: kingslynn / torquay
User status: Offline
|
get switches from a calibra and put them in the two holes behind the heater slide pannel. have to cut some holes in them or i think you can also buy the plastic bit from vaux with holes precut in? depending on what car you have there may/ maynot be a loom in there already. if you do have the loom you need to put fuses in the box ( cant rember what numbers but nx to eachother) then save fukin around a run wires from the back of the switch down under the carpet and into the seats. you'l read/here that there is a multiblock under each seat for the heater. absulote bollocks. ide like to see a pic of it from anyone making such a claim
|
ad-sport
Member
Registered: 16th May 07
User status: Offline
|
i used the correct connectors under the seats, dead easy to fid when you have the seats out (when fitting) ill try to get a pic up of the plugs tmoro,and my sport has a 60/40 split rear back rest
|
