Ash_EP3
Member
Registered: 15th May 07
Location: Melksham, Wiltshire
User status: Offline
|
At 4pm today the beast is going in!
I have checked:
all of the lights (brake lights, reverse lights, side lights etc)
all of the fluids
I am going to:
Give it a good clean (inside and outside)
Check my tyre pressure
& Give it a good hard blast up the dual carriageway before it goes in!
Me and my dad were taking my alloy wheels off to put the old (Standard) ones back in but we noticed that the tyres were absolutely f****d
When I mean f****d the tyres were bald on the front two  , and one of the rear tyres had a "dent" in the side wall 
And my current alloys have brand new tyres on, with plenty of tread left
So I left the alloys on, which I hope is ok as I was going to take them off because they rubbed slightly on the back (This isn't noticeable)
Is there anything I should look out for? / Have I missed anything?
Thanks in advance  
|
Dan
Premium Member
Registered: 22nd Apr 02
Location: Gorleston on Sea, Norfolk
User status: Offline
|
Just stick it in for test, what ever it fails/advise on just fix and re test. All i ever do
Adult GiftsClick here to vist us
|
Ash_EP3
Member
Registered: 15th May 07
Location: Melksham, Wiltshire
User status: Offline
|
Well I have the results and......
It passed 
There was one advisory note tho and that is that one of my wheel bearings needs a bit of tightening up on the back!! 
|
Rob E
Member
Registered: 1st Jan 06
Location: Madeley, Stafford....I want to live back in Wales!
User status: Offline
|
two min job to tighten the rear wheel bearings
[Edited on 11-02-2008 by Rob E]
|
