Kano
Member
Registered: 29th Aug 04
Location: Fife
User status: Offline
|
Following on from the thread regarding painting using rattle tins I thought I'd post some pics of a wing I've been doing for my sisters corrola..
Car got reversed into the other night so old wing was useless so bought a new one and got to work..
These pics are before I start to wet sand it and buff it up but its looking pretty good so far..
Will get some pics of it on the car in the next week or so... see if I can change some peoples minds about a good finish being possible..
Flash was on so the mettalic stands out quite a bit, its a lot more subtle than that..
Comments welcome!
|
STEvieXE
Member
Registered: 21st Jan 03
Location: Ballymena N.I.
User status: Offline
|
impossible to tell with those pics and almost any pics
|
All Torque
Member
Registered: 17th Nov 05
Location: Milton Keynes Drives: Ford Focus TDCi
User status: Offline
|
Good work 
|
j7 gkk
Member
Registered: 16th Jun 05
Location: Sheffield
User status: Offline
|
not a bad finish there matey, the only thing i have against rattle cans are they are still only 1pack instead of 2pack
|
STEvieXE
Member
Registered: 21st Jan 03
Location: Ballymena N.I.
User status: Offline
|
plus they are so expensive
|
