Jos
Member
Registered: 17th Nov 06
User status: Offline
|
Right, I'm about to swap my suspension for a set of AVO coilovers.
I don't really want the coilover to end up as an "interior accessory"  so what should I strengthen? The turrets and beam mounting points?
And, how should I go about doing so?
cheers 
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
rears will be fine iirc, they use seperate springs don't they?
[Edited on 04-12-2006 by Robin]
|
jamesvalver
Member
Registered: 21st Feb 03
Location: Bury St Edmunds, Suffolk
User status: Offline
|
i think the avo's have the spring and damber as one on the rear (simular to mcphearson strut). seam weld the rear turrets and fit a strut brace
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
or do nothing, like broster and muppetsport.
|
Jos
Member
Registered: 17th Nov 06
User status: Offline
|
the AVO kit are coilovers on all four corners 
Thanks both, I was expecting quite a lot of work to be done 
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
their fairly strong to start with.
bit of seam welding would be more than enough.
BTW, is that Nova still available?
|
Jos
Member
Registered: 17th Nov 06
User status: Offline
|
Ah, the Nova ones weren't particually strong - so I assumed the same on the Corsa.
you know Robin, I was just about to reply to your (numerous) pm's
Yes it is, but there's a lot of interest
[Edited on 04-12-2006 by Jos]
|
