alex_gsi
Member
Registered: 19th Jun 06
User status: Offline
|
bought some shrick cams off ebay couple of months back for dirt cheap and i would like to know if anyone has the same ones as me that knows what gains they had from them?
also does anyone know the website or phone number of the company that makes them so i can find out the max lift and duration of the cams?
the number of the cams is: 281E1 or 56100 ( there are 2 numbes on the pulley side of the shaft)
|
flash22
Member
Registered: 13th Sep 05
User status: Offline
|
schricks site is here.... http://www.drschrick.de/english/index.php
Some info on the cams
Part number 281.E1.561-00
Cam Lift (mm) I/U 9,5
Opening Angle I/U 264/ /110
€ 349,00
info was from here http://www.powerkings.nl/produkten/nokkenassen/Schrick%20Nokkenassen.htm
[Edited on 27-06-2006 by flash22]
|
alex_gsi
Member
Registered: 19th Jun 06
User status: Offline
|
whats the lift on standard cams then?
|
flash22
Member
Registered: 13th Sep 05
User status: Offline
|
standard cam info should be in the haynes manual. a snap shot from the schrick catalogue
[Edited on 27-06-2006 by flash22]
|
alex_gsi
Member
Registered: 19th Jun 06
User status: Offline
|
cheers for that guys! i have been told that it can be run on standard pulleys (best to fit verniers but cant afford them at the mo) but can they be run on standard lifters aswell?
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
whats the current engine spec mate?
|
alex_gsi
Member
Registered: 19th Jun 06
User status: Offline
|
hi at the mo its only got a filter, exhaust and the cams its a c16xe, but becuz im at uni studying motorsport iv made my own power box and im just designing my own manifold to fit it to. but also wanting a 4 branch and chip.
the engine has just been fully rebuilt by myself and had the head skimmed and everything so it will run ok until i get the other mods done
|
