20XE Where these bits go?? - Corsa Sport - for Vauxhall and Opel Corsa B, Corsa C and Corsa D

Not logged in [Login - Register]

You Are Not Registered Or Not Logged In

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » 20XE Where these bits go??

New Topic

New Poll

Subscribe | Add to Favourites

You are not logged in and may not post or reply to messages. Please log in or create a new account or mail us about fixing an existing one - register@corsasport.co.uk

There are also many more features available when you are logged in such as private messages, buddy list, location services, post search and more.

the_legend_of_yrag

Member

Registered: 7th Jul 03
Location: Cambridgeshire
User status: Offline

10th Jul 05 at 16:45

A few hoses im not sure about here:

In the first pic ive got the hose below the ground wire that is curved.

Next are the two long ones ive got laying over the rocker cover, the thin one and the thicker one...

Then the little 90 degree one on that metal bracket where im not sure where it bolts too

And this long hose from my cav, preety sure it was too the water tank which was mounted at the front of the cav but not sure where the other end went.

Above the heater matrix where the hose goes to the rad, theres another hole for a pipe?

The two bulkhead ones here, left on is sooo close to my inlet manifold, and im sure its this one that goes into the o/s part of heater matrix on the block?

And the n/s one on the block to the header tank? But what goes to n/s one on the bulkhead?

And this little 90 degree one on top of the fuel rail?

You can tell ive lost the bit of paper i wrot down on what goes where when i took the engine apart in febuary

Cheers

myke

Member

Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline

10th Jul 05 at 20:27

one of the hoses from the banjo goes from the end of the head to the header tank inlet. you can cut the banjo down the middle and dispose of the other bit.

2 vacuum hoses in the 2nd pic go to the vent valve in the third pic, and the fuel pressure regulator in the last pic.

the long bit probably goes from the expansion at the top n/s of the rad to the 2nd inlet on the header.

end of the cylinder head goes to one of the matrix stubs, and the other goes to the hard piping following behind the block.

the_legend_of_yrag

Member

Registered: 7th Jul 03
Location: Cambridgeshire
User status: Offline

11th Jul 05 at 16:52

cheers mate clears a few things up