Happy_2008
Member
Registered: 13th Mar 01
Location: Kent
User status: Offline
|
Just found out that the end of my amp wire is too big for my amp. I recently bought a genesis amp profile 4 but the clip on the end of the amp wire is too big. As i going to start the job 2morow would it be a good idea to hammer the clip until it fits or somehow replace the end clip???
|
myke
Member
Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline
|
is it a large fork terminal?
if so either crimp on a slightly smaller one, or lop off one of the prongs on the fork and just stick one of them in the amp connection.
|
Happy_2008
Member
Registered: 13th Mar 01
Location: Kent
User status: Offline
|
Nope its a loop terminal. I somehow need to hammer this to half its size 
|
myke
Member
Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline
|
mole grips on it and fold it in half lengthways?
|
Happy_2008
Member
Registered: 13th Mar 01
Location: Kent
User status: Offline
|
Well i have so far found out the the wiring kit i bought is 4gauge and my amp will only take 8 gauge or smaller i think. So far i have been recommended to either:
1) file down or hammer the loop terminal until it fits
2) Replace the terminal with an 8 gauge
3) Buy a distribution block.
I am really tempted to go with option one first and it that doesnt work then i will work on option 2.
|
