CorsaGSI_DK
Member
Registered: 10th Jun 02
Location: Copenhagen, Denmark
User status: Offline
|
quote:
Originally posted by Dave A
cost of the pistons?
Again...it's hard to tell because they were a part of the kit. The kit comprised of:
Pistons + wrist pins + rings
Complete gasket set incl. copper head gasket
HP Toga bearings (main + rod)
HP Toga valve seals
Head bolts
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
and how much was the kit?
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
to be picky there is writing stamped onto the gasket
now i may be wrong but in engineering somthing like that, wont the little
pockets or air that are created cause a hot spot between the head/gasket and block?
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
im just saying as somthing a bit simlilar "not a lot" different forces involved etc but
a series of makers stamp were on a train wheel and it caused it to fail.
|
CorsaGSI_DK
Member
Registered: 10th Jun 02
Location: Copenhagen, Denmark
User status: Offline
|
quote:
Originally posted by Dave A
and how much was the kit?
PM sent
|
CorsaGSI_DK
Member
Registered: 10th Jun 02
Location: Copenhagen, Denmark
User status: Offline
|
quote:
Originally posted by Adam-D
to be picky there is writing stamped onto the gasket
now i may be wrong but in engineering somthing like that, wont the little
pockets or air that are created cause a hot spot between the head/gasket and block?
I have no idea, TBH. The writing is done with tiny 'dots'...very difficult to feel by hand.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
|
