kev
Organiser: North East
Premium Member
Registered: 16th Jun 09
Location: Newcastle
User status: Offline
|
as above people, does anyone on here make these up?
i can make a bodge job one just woundering if anyone makes them up 
chrome? etc?
^ green circle above which part i mean.
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
That isn't the EGR.
|
Corsa_Quadz
Member
Registered: 24th Feb 08
Location:
User status: Offline
|
Thats the SAI for warming the cat, doesnt make any difference with it on or off. Just take the pipe off and blank with a cork or something if you want to bodge 
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
make one like that, it took me about 3 minutes to make out of some 4mm aluminium
[Edited on 08-11-2009 by Sean-B]
|
kev
Organiser: North East
Premium Member
Registered: 16th Jun 09
Location: Newcastle
User status: Offline
|
quote:
Originally posted by Corsa_Quadz
Thats the SAI for warming the cat, doesnt make any difference with it on or off. Just take the pipe off and blank with a cork or something if you want to bodge
i DONT want a bodge job mate 
|
kev
Organiser: North East
Premium Member
Registered: 16th Jun 09
Location: Newcastle
User status: Offline
|
quote:
Originally posted by Sean-B
make one like that, it took me about 3 minutes to make out of some 4mm aluminium
[Edited on 08-11-2009 by Sean-B]
thats looks even better again 
how did you make a template? 
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
take the whole SAI unit off the manifold. There is a thin metal gasket between the unit and the SAI unit.
Use this as your template obviously deleting the main hole.
Then using the original bolt, bolt the plate you have made, with the original gasket in-between, to the manifold
[Edited on 08-11-2009 by Sean-B]
|
kev
Organiser: North East
Premium Member
Registered: 16th Jun 09
Location: Newcastle
User status: Offline
|
quote:
Originally posted by Sean-B
take the whole SAI unit off the manifold. There is a thin metal gasket between the unit and the SAI unit.
Use this as your template obviously deleting the main hole.
Then using the original bolt, bolt the plate you have made, with the original gasket in-between, to the manifold
[Edited on 08-11-2009 by Sean-B]
i "asked" does anyone 'make' them on here and sell them? i.e chromed? 
ive seen dodgey ones been made before etc 
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
quote:
Originally posted by kevcr
quote:
Originally posted by Sean-B
take the whole SAI unit off the manifold. There is a thin metal gasket between the unit and the SAI unit.
Use this as your template obviously deleting the main hole.
Then using the original bolt, bolt the plate you have made, with the original gasket in-between, to the manifold
[Edited on 08-11-2009 by Sean-B]
i "asked" does anyone 'make' them on here and sell them? i.e chromed?
ive seen dodgey ones been made before etc
fine
|
